Rear Cross-Member Removal - Magnum V8-57L VIN H (2005)
CAUTION: To avoid damaging other components of vehicle, do not lower crossmember any further than necessary to install coil spring
(2).
19. Slowly lower jack allowing right side of cross-member to drop. Do not lower jack at a fast rate. Lower jack just enough to allow spring (2)
Installation. Do not lower jack any further than necessary.
NOTE: Before installing coil spring, make sure isolators (1 and 5) are completely installed on ends of spring.
20. Install coil spring (2) with isolators into spring pocket of spring link fitting the lower isolator to the shape of the pocket, then align top of spring
with body mount.
21. Carefully raise jack, guiding coil spring and lower end of shock absorber (1) into mounted positions. Once shock absorber (1) lower mounting hole
lines up with hole in spring link (3), stop jacking.
22. Install lower shock mounting bolt (2) and nut (4). Do not tighten at this time.
