Magnum V8-5.7L VIN H (2005)
4. If separated, install upper mount (1) onto coil spring (2). Match step in upper isolator to end of spring coil.
5. Install lower spring isolator (2) on shock body (3).
6. Install jounce bumper (4) on shock shaft, small end first.
7. Install shock through bottom of coil spring until lower spring isolator (on shock) contacts lower end of coil spring. Match step built into isolator
(1) to lower coil end (2). Once in this position, stabilizer bar bracket, or clevis key on AWD models, should point straight inward toward
Compressor body. If not, rotate isolator on shock body until alignment is achieved when isolator is correctly positioned with lower spring coil.
8. Install clamp to hold shock and coil spring together.
