Magnum V8-5.7L VIN H (2005)
INSTALLATION
AWD
NOTE: Before installing hub and bearing on end of axle half shaft, ensure isolation washer is present on end of half shaft. Inspect washer making
sure it is not worn or damaged. Washer can be installed in either direction on shaft.
1. Slide hub and bearing (2) onto axle half shaft (1). Position hub and bearing onto knuckle, lining up mounting bolt holes.
2. Install four bolts (3) fastening hub and bearing in place. Tighten mounting bolts to 68 Nm (50 ft. lbs.) torque.
3. Install brake rotor, then disc brake caliper and adapter assembly.
