Magnum V8-5.7L VIN H (2005)
32.
Apply the service brake and stop the wheels from turning.
33.
Repeat steps 29 - 32 two more times.
NOTE:
At times, the transmission may go into "limp-in" mode due a to transmission generated DTC. The DTC must be erased/cleared before proceeding
further. The transmission fluid may not be properly circulated in the transmission if the transmission remains in "limp-in" mode.
34.
Stop the engine and place the transmission in the PARK "P" position.
35.
Raise the vehicle.
36.
Remove the transmission oil pan and filter. Drain the transmission fluid.
37.
Thoroughly clean the transmission oil pan and pan mating surfaces.
38.
Install a new transmission oil filter, p/n 52108325AA.
39.
Install the transmission oil pan (gasket is reusable). Torque the pan fasteners to 8 Nm (71 in. lbs.).
WARNING:
Risk of accident from vehicle starting off by itself when engine running. Risk of injury from contusions and burns if you insert your hands into the
engine when it is started or when it is running. Secure vehicle to prevent it from moving off by itself. Wear properly fastened and close-fitting work
clothes. Do not touch hot or rotating parts.
CAUTION:
Transmission oil temperature readings are taken using the StarSCAN(TM) tool. The transmission oil temperature can be read ONLY when the gear
selector and transmission are in either the Reverse "R" or in one of the Drive "D" / forward gear positions. Always set the vehicle park brake AND
apply the vehicle service brake when taking transmission oil temperature readings. Take a transmission oil temperature reading and return the
transmission to the Park "P" position. When the vehicle is in either Park "P" or Neutral "N" the StarSCAN(TM) displays the ENGINE coolant
temperature (not the transmission oil temperature).
NOTE:
The WK is equipped with its own dipstick. Read the oil level on the transmission dipstick when the transmission oil temperature is either 70° F (21°
C) or 180° F (82° C).
40.
Monitor the transmission oil temperature:
a.
Set the vehicle parking brake.
b.
Connect the StarSCAN(TM) to the vehicle diagnostic link connector.
c.
Apply the vehicle service brake. Start the engine and let it run at idle speed with the transmission selector in the Park "P" position.
d.
With the service brake applied, shift through the transmission modes several times with the vehicle stationary and the engine idling.
e.
Return the transmission selector to the Park "P" position.
f.
With the engine running, allow the transmission to warm up.
g.
Apply the vehicle service brake, shift the transmission into Reverse "R" or Drive "D" position, and monitor the transmission oil temperature
using the StarSCAN(TM) Shift the transmission back into the Park "P" position.
