Magnum V8-5.7L VIN H (2005)
1. Install output shaft bearing in the rear transmission housing. Using Bearing Installer 9287 (1), install the output shaft bearing (2) into the
transmission housing. The closed side of the plastic cage must point towards the parking lock gear.
2. Install the retaining ring (1). Ensure that the retaining ring is seated correctly in the groove.
3. Check that there is no play between the bearing and the retaining ring using feeler gauge.
4. There must be no play between the retaining ring and the bearing. If the ring cannot be installed, a thinner ring must be used. If there is play
between the ring and the bearing, a thicker ring must be installed. Retaining rings are available in thicknesses of 2.0 mm (0.079 inch), 2.1 mm
(0.083 inch), and 2.2 mm (0.087 inch).
5. Install the output shaft washer onto the output shaft.
6. Install a new transmission rear seal into the transmission case with Seal Installer 8902A (1).
7. Verify that the transmission is in PARK in order to prepare for the installation of the output shaft nut.
8. Install the propeller shaft flange onto the output shaft and install an new flange nut. Tighten the flange nut to 200 Nm (147.5 ft. lbs.).
