Magnum V8-5.7L VIN H (2005)
9.
Place the valve body assembly, springs, accumulator, filter and bolts (valve body and filter) on a clean surface.
10.
A.
If the anchor shaft has not come completely out of the hole: Use a pair of needle nose pliers and gently work the shaft into the hole until it
just comes out the other side of the case. Continue with Step 13.
B.
If the anchor shaft has come out of the hole and is visible in the drain hole: Use a magnet to extract it. Secure a tie wrap (P/N 04641780) to
the anchor shaft about 1/4" from one end as shown in Figure 4.
C.
If you cannot see the anchor shaft:
Obtain a new anchor shaft (P/N 04431999) and secure a tie wrap (P/N 04641780) to the anchor shaft about 1/4" from one end as shown in
Figure 4.
NOTE:
If you cannot see the old anchor shaft, it has dislodged into the transmission adaptor or transmission extension housing. It is not necessary to
remove the old anchor shaft as it will not harm the transmission, transmission adaptor, or the transmission extension housing.
