Magnum V8-5.7L VIN H (2005)
f.
When the download is complete, select "Close"
13.
Download the file from the StarSCAN to the vehicle. Using the StarSCAN at the "Home" screen:
a.
Select "ECU View"
b.
Browse the list of controllers using the scroll arrows. Highlight the TCM.
c.
Select "More Options"
d.
Select "ECU Flash"
e.
Highlight the appropriate TCM "Calibration" from the list.
f.
Select "Update Controller"
g.
When update is completed, select "OK"
NOTE:
Due to the TCM programming procedure, a DTC may be set in other modules (TCM, BCM, MIC, SKIM, etc.) within the vehicle, if so equipped.
Some DTC's may cause the MIL to illuminate. Check all modules using "ECU View" from the Home screen, record the DTC's, and erase these
DTC's prior to returning the vehicle to the customer. Erase any DTC's in the PCM only after all other modules have had their DTC's erased.
14.
Using StarSCAN at the 'Home" screen:
a.
Select ECU view.
b.
Select Transmission.
c.
Select Misc. Functions.
d.
Select Initialize EGS-52.
NOTE:
The following step is required by law.
15.
Type the necessary information on the "Authorized Modification Label" p/n 04275086AB and attach near the VECI label (Fig. 1).
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
