Magnum SRT-8 V8-6.1L VIN 3 (2006)
Antenna Cable: Service and Repair
NOTE: A battery reconnect procedure must be performed anytime the battery has been disconnected.
REMOVAL
1. Disconnect and isolate battery negative cable.
2. Remove right side cowl trim panel.
3. Disconnect antenna cable from instrument panel antenna cable.
4. Remove right side front and rear door scuff plates.
5. Remove right side C-pillar trim panel.
6. Disconnect antenna cable from antenna module.
7. Move floor carpet aside.
8. Remove antenna cable.
INSTALLATION
1. Position antenna cable and secure to wire harness.
2. Connect antenna cable to antenna module.
3. Connect antenna cable to instrument panel antenna cable.
4. Install right side C-pillar trim panel.
5. Install right side front and rear door scuff plates.
6. Install right side cowl trim panel.
7. Connect battery negative cable.
