Magnum SRT-8 V8-6.1L VIN 3 (2006)
Security Lamp/Indicator: Description and Operation
VTSS/SKIS INDICATOR LAMP
DESCRIPTION
The Sentry Key Remote Entry System (SKREES), sometimes referred to as the Sentry Key Immobilizer System (SKIS), uses an indicator light to convey
information on the status of the system to the customer. This light is shared with the Vehicle Theft Security System (VTSS). The light is located in the
instrument panel switch pod, just to the right of the cluster. The indicator light is controlled by the Cab Compartment Node (CCN), via the Controller
Area Network (CAN) data bus based upon messages it receives from the Sentry Key Remote Entry Module (SKREEM), sometimes referred to as the
Wireless Control Module (WCM),on the CAN data bus, and is hard wired to the cluster.
OPERATION
The VTSS/SKREES lamp is controlled according to Sentry Key Remote Entry Module (SKREEM), sometimes referred to as the Wireless Control
Module (WCM), messages. Then, the SKREEM/WCM sends messages to the Front Control Module (FCM) to operate the light based upon the results of
the SKREES/SKIS self tests. The light may be actuated in two possible ways, flashing or on solid. If the light comes on and stays on solid after a
power-up test, this indicates that the SKREEM/WCM has detected a system malfunction. If the SKREEM/WCM detects an invalid key when the ignition
switch is moved to the ON position, it sends a message on the CAN bus to the FCM, to flash the light. The SKREEM/WCM can also send a message to
flash the light and generate a single audible chime at the same time. These two events occurring simultaneously indicate that the SKREES/SKIS has been
placed into the "Customer Learn" mode. If the light comes on and stays on after the power-up test, diagnosis of the SKREES/SKIS should be performed
using a scan tool and the appropriate diagnostic information. The light is not a serviceable component.
