dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Driver/Vehicle Information Display|Service and Repair > < Electronic Vehicle Information Center
Page 1
background image

Driver/Vehicle Information Display: Testing and Inspection
Universal Transmitter

If the Universal Transmitter is inoperative, but the Electronic Vehicle Information Center (EVIC) is operating normally. Retrain the Transmitter with a
known good transmitter as instructed and test the Transmitter operation again.

If the unit is still inoperative, test the universal transmitter with Radio Frequency Detector special tool. as described below:

1. Turn the Radio Frequency (RF) Detector ON. A "chirp" will sound and the green power LED will light. If the green LED does not light, replace

the battery.

2. Hold the RF detector within one inch of the TRAINED universal transmitter and press any of the transmitters buttons.
3. The red signal detection LEDs will light and the tool will beep if a radio signal is detected. Repeat this test for each button. If any button is

inoperative, replace the universal transmitter assembly.

If both the Transmitter and the EVIC module are inoperative, refer to testing for further diagnosis. Refer to the appropriate wiring information for
complete circuit schematic or connector pin-out information.

Driver/Vehicle Information Display|Service and Repair > < Electronic Vehicle Information Center