Magnum SRT-8 V8-6.1L VIN 3 (2006)
Remote Switch: Service and Repair
NOTE: A battery reconnect procedure must be performed anytime the battery has been disconnected.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the driver airbag.
3. Using a trim stick, gently pry switch from steering wheel at locations shown.
4. Disconnect electrical connector.
5. Remove switch from steering wheel.
INSTALLATION
1. Connect electrical harness connector to switch.
2. Position switch and press into place.
3. Install the driver airbag.
4. Connect battery negative cable.
