Magnum SRT-8 V8-6.1L VIN 3 (2006)
2. If removed on SRT8 models, install the lower fascia onto the rear fascia assembly (6) using new metal retaining clips.
3. If equipped and removed, install the park assist sensors into the rear fascia assembly.
4. Position the rear fascia assembly to the vehicle and connect the license plate lamp and park assist wire harness connector (4), if equipped.
5. Engage the two push-pin retainers (2) into the two slots (3) in each side of the rear fascia assembly by pushing the fascia forward.
6. Install the push-pin retainers (5) (three-sedan, three-wagon, one-charger) that secure the rear fascia assembly to the decklid sill.
7. On sedan models, install the two bumper stops (1).
8. Raise and support the vehicle.
9. Install the screw (2) that secures the rear fascia assembly to the nut insert (1) in each quarter panel. Tighten the screws securely.
10. Position each rear wheel house splash shield (2) to the rear fascia assembly (3) and install the push-pin retainers (1).
11. Lower the vehicle.
