Magnum SRT-8 V8-6.1L VIN 3 (2006)
3. For the driver side handle only, reach up into the back of the door shell to engage the lock actuator link (3) to the lock cylinder and snap the plastic
clip over the link to secure it to the lock cylinder.
4. Reach up into the back of the door shell to engage the latch release link (2) to the exterior door handle (1) and snap the plastic clip over the link to
secure it to the handle.
5. With the upper screw (1) hand-started into the pull cup bracket (2), position the screw into the keyed hole on the inside of the front door.
6. Install and tighten the screw (3) that secures the bottom of the pull cup bracket and the bottom of the window regulator rear rail to the inside of the
front door. Tighten the screw to 11 N.m (100 in.lbs.).
7. Tighten the screw that secures the top of the pull cup bracket to the inside of the front door. Tighten the screw to 10 N.m (90 in.lbs.).
8. Reinstall the watershield onto the inside of the front door.
9. Reinstall the speaker onto the inside of the front door.
10. Reinstall the trim panel onto the inside of the front door.
