Magnum SRT-8 V8-6.1L VIN 3 (2006)
Trunk / Liftgate Striker: Service and Repair
LATCH STRIKER
REMOVAL
1. Open the liftgate.
2. Remove the scuff plate trim panel from the inside of the liftgate opening lower panel (3). Refer to Trim Panel.
3. Mark the latch striker (2) location on the inside of the liftgate opening lower panel to aid reinstallation.
4. Remove the two screws (1) that secure the latch striker to the inside of the liftgate opening lower panel.
5. Remove the latch striker from the vehicle.
INSTALLATION
1. Position the liftgate latch striker (2) to the inside of the liftgate opening lower panel (3).
2. Install and tighten the two screws (1) that secure the latch striker to the liftgate opening lower panel. Tighten the screws to 28 N.m (21 ft.lbs.).
3. Adjust the latch striker position as necessary to achieve proper liftgate latch operation.
4. Reinstall the scuff plate trim panel to the liftgate opening lower panel. Refer to Trim Panel.
5. Close the liftgate.