Magnum SRT-8 V8-6.1L VIN 3 (2006)
21. Using Puller (2), Special Tool 9360, separate ball joint stud from knuckle.
22. Remove tool.
23. Remove left and right engine mount nut.
24. Remove nut (1) from end of ball joint stud.
25. On each side of vehicle, remove bolts (2) fastening stabilizer bar isolator retainer (3) in place.
26. Remove stabilizer bar with isolators and retainers from vehicle.
27. Support the engine cradle (special tool # 8534) with a suitable lifting device.
28. Using a grease pencil or equivalent, mark the position of the engine cradle to aid installation.
29. Remove the four engine cradle bolts and lower the cradle.
30. Remove the control arms, if required.
INSTALLATION
NOTE: Although AWD and RWD upper control arms are similar in appearance, they are not interchangeable.
