Magnum SRT-8 V8-6.1L VIN 3 (2006)
14. Raise right side of crossmember (1) into mounted position. Install right side crossmember mounting bolts (2 and 3). Snug, but do not fully tighten
bolts at this time.
15. Remove both front and rear crossmember mounting bolts (2 and 3) on left side of vehicle.
CAUTION: To avoid damaging other components of vehicle, do not lower crossmember any further than necessary to install coil spring
(2).
16. Slowly lower jack allowing left side of crossmember to drop. Do not lower jack at a fast rate. Lower jack just enough to allow spring (2)
Installation. Do not lower jack any further than necessary.
NOTE: Before installing coil spring, make sure isolators (1 and 5) are completely installed on ends of spring.
17. Install coil spring (2) with isolators into spring pocket of spring link fitting the lower isolator to the shape of the pocket, then align top of spring
with body mount.
18. Carefully raise jack, guiding coil spring and lower end of shock absorber (1) into mounted positions. Once shock absorber (1) lower mounting hole
lines up with hole in spring link (3), stop jacking.
19. Install lower shock mounting bolt (2) and nut (4). Do not tighten at this time.
