Magnum SRT-8 V8-6.1L VIN 3 (2006)
NOTE: If equipped with AWD, when removing crossmember mounting bolts in following step, be sure to not to misplace spacers (1) between
cross-member mounts (2) and body.
25. Remove both front (3) and both rear (2) mounting bolts fastening crossmember (1) in place.
26. Slowly lower crossmember using jack. Do not lower jack at a fast rate. Lower just enough to allow propeller shaft removal from rear axle
differential. Do not lower jack any further than necessary. Slide propeller shaft out of rear axle differential and allow bungee cord previously
installed to support.
27. Lower crossmember until crossmember is at a comfortable working level to access bushings. Support rear suspension assembly using jack stands
to help stabilize assembly during bushing service.
