Magnum SRT-8 V8-6.1L VIN 3 (2006)
NOTE: Ensure Installer (3), Special Tool 9031-7, is positioned that it will clear compression link bracket (1) while bushing is being installed.
3. Tighten Press (2) screw-drive, pressing bushing into crossmember. Install bushing until bushing can flange contacts surface of crossmember.
4. Remove tools.
5. Verify bushing closely lines up with reference marks applied during removal.
6. Install bolt and nut as shown (1) fastening compression link (3) to crossmember. Do not tighten bolt at this time.
NOTE: Do not reinstall coil springs on spring links at this time. Install as directed in later steps.
