Magnum SRT-8 V8-6.1L VIN 3 (2006)
6. Assemble tools over bushing as shown (See list). Ensure Receiver, Special Tool 9032-1, sets against crossmember and not welds.
-
(2) Remover 9032-2
-
(3) Press C-4212F
-
(4) Receiver 9032-1
7. Tighten Press screw-drive, pressing bushing out of crossmember.
INSTALLATION
1. Position bushing (1) over rear of crossmember bushing bore.
2. Assemble tools over bushing and crossmember as shown (See list). Ensure Receiver, Special Tool 9032-3, is positioned to avoid welds on rear of
crossmember bushing bore.
-
(2) Remover/Installer 9032-2
-
(3) Press C-4212F
-
(4) Receiver 9032-3
3. Tighten Press screw-drive, pressing bushing into crossmember. Install bushing until screw-drive stops, when bushing contacts Receiver on
opposite side of crossmember.
4. Remove tools.
