Magnum SRT-8 V8-6.1L VIN 3 (2006)
SRT8 INSTALLATION
1. Prime the spoiler with 3M adhesion promoter (Part No.06396) in the areas the tape will be applied inboard and adjacent to the hider lip at the top
and bottom edge of the spoiler attaching surface.
NOTE:Keep all contaminants (fingers, gloves, cloths, etc.) off the adhesive surface of the tape while applying it.
2. Cut 2 pieces of 3M acrylic plus attachment tape, 3M p/n 06384, 1330mm (52.4 in.)
3. Remove one side of the backing paper from a piece of the attachment tape and apply it to the spoiler so it is adjacent to the hider lip at the top of
the spoiler, being careful not to entrap air between the spoiler and tape.
4. Remove one side of the backing paper from a piece of the attachment tape and apply it to the spoiler so it is adjacent to the hider lip at the bottom
of the spoiler, being careful not to entrap air between the spoiler and tape.
5. Use a hard rubber roller or firm hand pressure to securely bond the tape pieces to the spoiler.
NOTE:Important Installation Precautions and Recommendations:
-
Application temperatures below 60F (16C) should be avoided. If necessary, warm the vehicle surface with a heat gun to obtain the recommended
vehicle surface application temperature of 60F to 1 10F (16C to 43C).
-
It is important that the vehicle not have any condensation on it (i.e., a cold vehicle moved into a warm shop).
-
DO NOT touch or contaminate the exposed adhesive surface of the tape.
-
DO NOT apply the new tape over the old tape or tape residue.
-
DO NOT let the tape sit around with the adhesive surface exposed.
-
DO NOT use an adhesion promoter on the painted surface of the deck lid.
6. Peel a portion of the backing paper from both pieces of attachment tape on the drivers side of the spoiler.
