Magnum SRT-8 V8-6.1L VIN 3 (2006)
3.
Remove the surround seal from the part, (Fig. 1).
4.
Use adhesive remover (Isopropyl Alcohol) to remove excessive residue on the spoiler, concentrate on the corners where the foam blocks are
installed, (Fig. 1)
5.
Remove all fastener seals from part (remove any white clips that may have broken during removal.
6.
Install new white clips, as required, and/or replace all fastener seals
7.
Seal wire harness into the wiring grommet using RTV sealer, p/n 82300234, (Fig. 2)
8.
Use the procedures outlined on TechCONNECT 23-Body/Exterior/Spoiler to install the liftgate spoiler to the vehicle.
POLICY:
Reimbursable within the provisions of the warranty.
