Magnum SRT-8 V8-6.1L VIN 3 (2006)
9. Remove brake caliper (2) with pads from knuckle (3) and brake rotor (3).
10. Remove brake pads if needed from caliper.
NOTE: These calipers are not serviceable. Do not attempt disassembly.
INSTALLATION
CAUTION: Always inspect brake pads before installing disc brake caliper and replace as necessary.
1. Completely retract caliper pistons back into bores of caliper. Use hand pressure or a C-clamp may also be used to retract pistons, first placing a
wood block or used brake pad (not to be reused) over pistons before installing C-clamp to avoid damaging piston.
2. If removed install brake pads in caliper before installation).
3. Slide caliper with pads (2) over brake rotor (3) and align with knuckle (8).
4. Install caliper mounting bolts (1). Tighten bolts to 190 Nm (140 ft. lbs.) torque.
5. Install banjo bolt (4) attaching brake hose (5) to caliper (1). Install NEW washers (2, 3) on each side of hose fitting as banjo bolt is placed through
banjo fitting. Thread banjo bolt into caliper and tighten to 33 Nm (24 ft. lbs.) torque.
