Magnum SRT-8 V8-6.1L VIN 3 (2006)
6. Install tire and wheel assembly (1). Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.) torque.
7. Lower vehicle.
8. Remove brake pedal holding tool.
9. Connect battery negative cable (2) to battery post. It is important that this is performed properly.
10. Bleed (1) base brake hydraulic system as necessary.
CAUTION: If NEW brake pads have been installed, keep in mind that braking effectiveness might be somewhat reduced during the first brake
applications.
11. Road test vehicle making several stops to wear off any foreign material on brakes and to seat brake pads. If NEW brake pads are installed, they
need to be properly burnished.
