Magnum SRT-8 V8-6.1L VIN 3 (2006)
6. If equipped with Electronic Stability Program, connect wiring harness (6) connector to pressure switch (5).
7. Connect wiring harness (6) connector to brake fluid level switch (2) mounted in brake fluid reservoir (1).
8. Connect battery negative cable (2) to battery post. It is important that this is performed properly.
9. Fill master cylinder fluid reservoir (1) with clean, fresh Mopar® Brake Fluid or equivalent.
10. Install access panel in cowl area.
WARNING: Be certain a firm brake pedal is achieved prior to attempting vehicle operation. If a firm brake pedal cannot be achieved,
bleed entire brake hydraulic system and check for leaks.
11. Road test vehicle to ensure proper operation of brakes.
