Magnum SRT-8 V8-6.1L VIN 3 (2006)
1. Remove the center floor console.
2. Remove the two screws (1) that secure the floor console duct (2) to the center floor panel (3).
3. Disconnect the floor console duct from the floor distribution duct (4) and remove the floor console duct from the vehicle.
INSTALLATION
1. Position the floor console duct (2) into the vehicle.
2. Connect the floor console duct to the floor distribution duct (4).
3. Install the two screws (1) that secure the floor console duct to the center floor panel (3). Tighten the screws to 2.2 N.m (20 in. lbs.).
4. Install the center floor console.
Duct-Defroster
DUCT-DEFROSTER
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING
WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE
THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO
DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE
AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY OR DEATH.
NOTE:
-
Take the proper precautions to protect the front face of the instrument panel from cosmetic damage.
-
LHD model shown. RHD model similar.
