Magnum SRT-8 V8-6.1L VIN 3 (2006)
CAUTION: When installing the pulley and bearing assembly, DO NOT mar the friction surfaces of the pulley or premature failure of the clutch
will result.
4. Install the pulley and bearing assembly (1) onto the front cover of the A/C compressor. If necessary, tap the pulley gently with a block of wood (2)
placed on the pulley friction surface.
CAUTION: The snap ring must be fully and properly seated in the groove or it will vibrate out, resulting in a clutch failure and severe damage to
the A/C compressor.
NOTE: A new snap ring must be used to secure the pulley and bearing assembly to the A/C compressor. The bevel side of the snap ring must face
outward.
5. Using snap ring pliers (Special Tool C-4574 or equivalent) (2), install the external snap ring (1) that secures the pulley and bearing assembly (3) to
the front cover of the A/C compressor. Be certain that the snap ring is fully and properly seated in the groove.
