dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

A/C - Hot Air from Ducts at Start Up/Long Hot Drive|Page 5987 > < A/C - Hot Air from Ducts at Start Up/Long Hot Drive|Page 5981
Page 1
background image

Control Assembly: All Technical Service Bulletins
A/C - Hot Air from Ducts at Start Up/Long Hot Drive

NUMBER: 24-014-05 REV. A

GROUP: Heater & A/C

DATE: November 19, 2005

THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 24-014-05, DATED August 11, 2005, WHICH SHOULD BE REMOVED
FROM YOUR FILES ALL REVISIONS ARE HIGHLIGHTED WITH **ASTERISKS** AND INCLUDES THE ADDITION OF AN
APPLICABILITY NOTE.

SUBJECT:
Hot Air From A/C Ducts At Start Up and/or A/C System Doesn't Cool After Extended Driving In Hot And Humid Ambient Conditions

OVERVIEW:
This bulletin involves replacing the HVAC Manual Temperature Control.

MODELS:

2006

(LX)

300/Charger/Magnum

NOTE:

**This bulletin applies to vehicles built prior to August 12, 2005 and equipped with manual A/C (sales Code HAA).**

SYMPTOM/CONDITION:

While operating the vehicle with the A/C on, the vehicle operator notices that after a vehicle start sequence there is a hot blast of airflow from the A/C
vents and/or the vehicle operator notices that after a vehicle start sequence that the doors inside of the HVAC unit appear to be moving or calibrating.
The vehicle operator may also notice a loss of airflow from the vents and becomes uncomfortably warm after a long drive in hot and humid weather
while operating with the A/C on.

DIAGNOSIS:

If the vehicle operator describes the Symptom/Condition, perform the Repair Procedure.

PARTS REQUIRED:

REPAIR PROCEDURE:

1.

Remove I/P center bezel using the fiber stick to pry up the bezel without damaging the I/P padding.

2.

Disconnect electrical connectors for the A/C control, switch bank and clock if equipped.

3.

Remove the four 4 mm screws attaching the A/C control and remove the A/C control.

4.

Install revised manual A/C control, p/n 55111870AH. Tighten the screws to 2 Nm (17 in. lbs.).

5.

Connect the A/C control, switch bank and clock wiring connectors as equipped.

6.

Snap in the I/P center bezel to the center I/P.

7.

Start the vehicle. The HVAC doors will calibrate upon the initial start up of the vehicle.

POLICY:
Reimbursable within the provisions of the warranty.

A/C - Hot Air from Ducts at Start Up/Long Hot Drive|Page 5987 > < A/C - Hot Air from Ducts at Start Up/Long Hot Drive|Page 5981