Magnum SRT-8 V8-6.1L VIN 3 (2006)
11. Connect the HVAC wire harness (1) to the mode door actuator (2) and the blend door actuator (3) located on the driver side of the air distribution
housing (4).
12. If equipped with dual zone heating-A/C, connect the HVAC wire harness to the blend door actuator (5) located on the passenger side of the air
distribution housing.
13. Install the floor console duct.
14. Install the defroster ducts.
15. Install the instrument panel.
16. Reconnect the negative battery cable.
17. Refill the engine cooling system.
Air Inlet Housing Removal and Installation
HOUSING-AIR INLET
NOTE:
-
The air inlet housing must be removed from HVAC housing and disassembled for service of the recirculation-air door.
-
LHD model shown. RHD model similar.
REMOVAL
WARNING:
-
REFER TO THE APPLICABLE WARNINGS AND CAUTIONS FOR THIS SYSTEM BEFORE PERFORMING THE FOLLOWING
OPERATION. FAILURE TO FOLLOW THE WARNINGS AND CAUTIONS COULD RESULT IN POSSIBLE PERSONAL INJURY
OR DEATH.
-
ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING
WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND
ISOLATE THE NEGATIVE BATTERY (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM
CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY
TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL
AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY OR DEATH.
