Magnum SRT-8 V8-6.1L VIN 3 (2006)
6. Disconnect the HVAC wiring harness (1) from the evaporator temperature sensor (2), blower motor resistor or power module (3) (depending on
application) and the blower motor (4).
7. Disengage the two HVAC wire harness retainers (5) from the blower motor and remove the blower motor from the HVAC housing.
8. Remove the blower motor resistor or power module, depending on application.
9. Remove the evaporator temperature sensor.
10. Remove the two bolts (1) that secure the A/C expansion valve (2) to the evaporator tube tapping block located within the foam seal (3).
11. Remove the A/C expansion valve from the evaporator tube tapping block and foam seal.
12. Remove the O-ring seals from the evaporator tube fittings and discard.
13. Install plugs in, or tape over the opened evaporator tube fittings and all expansion valve ports.
