Magnum SRT-8 V8-6.1L VIN 3 (2006)
1. If removed, install the foam seal (2) over the tapping block of the A/C evaporator (1). If the seal is deformed or damaged, it must be replaced.
2. Install the A/C evaporator into the lower half of the HVAC housing (3). Make sure that the evaporator drain within the HVAC housing is clean
and unrestricted and that the insulator around the A/C evaporator is properly installed.
3. Install the upper half of the HVAC housing (3) onto the lower half of the HVAC housing (4).
4. Install the screws (2) that secure the two halves of the HVAC housing together. Tighten the screws to 2.2 N.m (20 in lbs.).
5. Install the HVAC wiring harness (1). Make sure the harness is routed through all wiring retainers.
