dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

18-031-05 > < Engine Controls - MIL ON/DTC's P2112 or P1521|Page 8145
Page 3
background image

l.

Verify the part number at the top of the "Flash PCM" screen has updated to the new part number.

NOTE:

Due to the PCM programming procedure, a DTC may be set in other modules (TCM, BCM, MIC, SKREEM, etc.) within the vehicle, if so equipped.
Some DTC's may cause the MIL to illuminate. From the "Home" screen select "System View". Then select "All DTCs". Press "Clear All Stored
DTCs" if there are any DTCs shown on the list.

NOTE:

The following step is required by law when reprogramming a PCM and/or TCM.

6.

Type the necessary information on the "Authorized Modification Label" p/n 04275086AB and attach near the VECI label (Fig. 1).

POLICY:
Reimbursable within the provisions of the warranty.

TIME ALLOWANCE:

FAILURE CODE:

Disclaimer:

This bulletin is supplied as technical information only and is not an authorization for repair.

18-031-05 > < Engine Controls - MIL ON/DTC's P2112 or P1521|Page 8145