Magnum SRT-8 V8-6.1L VIN 3 (2006)
mounting hole and nut is installed.
2. Insert sensor (1) through wheel (2) as shown keeping pressure against rear of metal valve stem (See Arrow). Potted side of sensor is to be
positioned toward wheel. Do not attempt to mount sensor otherwise, damage may occur.
3. Install sensor nut (with pressed-in washer) (3) by hand.
NOTE: Before tightening sensor nut, push downward on sensor housing (2) in an attempt to make it flush with interior contour of wheel (1).
4. While holding sensor in position, tighten sensor nut to 6.5 Nm (58 inch lbs.) torque.
CAUTION: Over-torquing the sensor nut by as little as 12 Nm (106 inch lbs.) may result in sensor separation from the valve stem. Under this
condition, the sensor may still function, however, the condition should be corrected immediately.
5. Mount tire on wheel following tire changer manufacturers instructions, paying special attention to the following to avoid damaging tire pressure
sensor:
