Magnum SRT-8 V8-6.1L VIN 3 (2006)
Camshaft Position Sensor: Service and Repair
SENSOR-CAMSHAFT POSITION
REMOVAL
The Camshaft Position Sensor (CMP) on the 6.1L V-8 engine (1) is bolted to the front/top of the timing chain cover (2).
1. Disconnect electrical connector (4) at CMP sensor.
2. Remove sensor mounting bolt (3).
3. Carefully twist sensor from timing chain cover.
4. Check condition of sensor O-ring.
INSTALLATION
1. Clean out machined hole in timing chain cover.
2. Apply a small amount of engine oil to sensor O-ring.
3. Install sensor (1) into timing chain cover (2) with a slight rocking action. Do not twist sensor into position as damage to O-ring may result.
CAUTION: Before tightening sensor mounting bolt, be sure sensor is completely flush to timing chain cover. If sensor is not flush, damage to
sensor mounting tang may result.
4. Install mounting bolt (3) and tighten to 12 N.m (105 in. lbs.)
5. Connect electrical connector (4) to sensor.
