Magnum SRT-8 V8-6.1L VIN 3 (2006)
FUEL SYSTEM HOSES, FITTINGS OR LINES, THE FUEL SYSTEM PRESSURE MUST BE RELEASED. REFER TO THE FUEL SYSTEM
PRESSURE RELEASE PROCEDURE. THIS MAY RESULT IN PERSONAL INJURY OR DEATH.
DISCONNECTION/CONNECTION
1. Perform fuel pressure release procedure. See: Fuel Filter/Fuel Pressure Release/Service and Repair
2. Disconnect negative battery cable from battery or auxiliary jumper terminal.
3. Clean fitting of any foreign material before disassembly.
4. To release fuel system component from quick-connect fitting, firmly push fitting towards component being serviced while firmly pushing plastic
retainer ring into fitting. With plastic ring depressed, pull fitting from component. The plastic retainer ring must be pressed squarely into fitting
body. If this retainer is cocked during removal, it may be difficult to disconnect fitting. Use an open-end wrench on shoulder of plastic retainer
ring to aid in disconnection.
5. After disconnection, plastic retainer ring will remain with quick-connect fitting connector body.
6. Inspect fitting connector body, plastic retainer ring and fuel system component for damage. Replace as necessary.
7. Prior to connecting quick-connect fitting to component being serviced, check condition of fitting and component. Clean parts with a lint-free cloth.
Lubricate with clean engine oil.
8. Insert quick-connect fitting into component being serviced until a click is felt.
9. Verify a locked condition by firmly push-pulling-push on fuel tube and fitting (15-30 lbs.).
10. Connect negative battery cable to battery or auxiliary jumper terminal.
11. Use the DRB III(R) scan tool ASD Fuel System Test to pressurize the fuel system. Check for leaks.
