Magnum SRT-8 V8-6.1L VIN 3 (2006)
Fuel Rail: Service and Repair
REMOVAL
WARNING: THE FUEL SYSTEM IS UNDER CONSTANT PRESSURE EVEN WITH ENGINE OFF. BEFORE SERVICING FUEL RAIL,
FUEL SYSTEM PRESSURE MUST BE RELEASED.
CAUTION: The left (3) and right (1) fuel rails are replaced as an assembly. Do not attempt to separate rail halves at connector tube (2). Due to design
of tube, it does not use any clamps. Never attempt to install a clamping device of any kind to tube. When removing fuel rail assembly for any reason, be
careful not to bend or kink tube.
1. Remove fuel tank filler tube cap.
2. Perform Fuel System Pressure Release Procedure. See: Fuel Filter/Fuel Pressure Release/Service and Repair
3. Remove negative battery cable at battery.
4. Remove flex tube (air cleaner housing to engine).
5. Remove electrical connector from MAP sensor (2) at rear of intake manifold (1).
6. Disconnect vacuum hose from fitting (3) at rear of intake manifold (1).
