Magnum SRT-8 V8-6.1L VIN 3 (2006)
Memory Positioning Module: Service and Repair
MODULE-SEAT MEMORY
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the driver seat cushion/cover (2).
3. Pivot the module upward and disconnect the electrical connectors (1).
4. Unsnap the memory seat module (4) from the side brackets.
5. Pull the module rearward to remove it from the front of the seat frame (3).
INSTALLATION
CAUTION: The Memory Seat Module (MSM) mounting tabs can be damaged during module installation. Use care to properly align tabs to prevent
binding that could result in tab breakage.
1. Place the module (4) into position making sure the mounting tabs are properly aligned with the front bracket.
2. Push down on the rear of the module (4) snapping the retaining clips into place in the side brackets.
3. Connect the MSM rear harness connectors (1).
4. Connect the MSM front harness connectors.
5. Install the driver seat cushion/cover (2).
6. Connect the battery negative cable.
7. Verify system and vehicle operation.
