Magnum SRT-8 V8-6.1L VIN 3 (2006)
Steering Column Control Module: Service and Repair
Assembly
ASSEMBLY
WARNING:To service any component of the SCCM, the entire assembly must be removed from the column. This must be done due to the clockspring
passing through the assembly and into the self docking connector. Failure to remove the assembly could damage the pins of the clockspring
and prevent the airbag system from operating properly.
1. Position the Steering Control Module (SCM) onto the multi-function switch.
2. Install the multi-function switch and SCM and tighten the three screws (1) from the bottom of the SCCM
3. Install the steering column telescoping lever (3).
