Magnum SRT-8 V8-6.1L VIN 3 (2006)
Steering Column Control Module: Service and Repair
Disassembly
DISASSEMBLY
WARNING:To service any component of the SCCM, the entire assembly must be removed from the column. This must be done due to the clockspring
passing through the assembly and into the self docking connector. Failure to remove the assembly could damage the pins of the clockspring
and prevent the airbag system from operating properly.
1. Remove the three clockspring screws (1) just far enough to release it from the SCCM. Leave them in the clockspring so it won't unwind.
2. Carefully pull straight up on clockspring to remove.
NOTE: After the clockspring is removed, there is only one more screw on the top side of the SCCM that needs to be removed and is located at
approximately the six o'clock position on the SCCM It holds the lower side of the steering angle sensor, the lower side of the electric tilt lever
assembly, or the strengthening strut if not equipped with electric tilt.
