Magnum SRT-8 V8-6.1L VIN 3 (2006)
3. Slide return hose from gear (1) onto right end of cooler (2). Install clamp securing hose in place.
4. Install belly pan.
5. Lower vehicle.
6. Connect battery negative cable (2) to battery post. It is important that this is performed properly.
7. Fill pump reservoir with fluid and perform pump initial operation procedure.
FLUID COOLER - SRT8
1. Install center tube of cooler over mounting clips attached to cooling module. Push cooler past clip retaining tabs allowing it to lock into place.
2. Slide return hose to reservoir (3) onto outlet of cooler (2). Install clamp (4) securing hose in place.
