Magnum SRT-8 V8-6.1L VIN 3 (2006)
2. Lubricate NEW O-ring on steering gear end of pressure hose with clean power steering fluid.
3. Install pressure hose (2) to steering gear (1). Do not tighten tube nut at this time.
4. Lubricate NEW O-ring on steering gear end of return hose with clean power steering fluid.
5. Install return hose (2) to steering gear (1). Do not tighten tube nut at this time.
6. Route pressure hose along left side of engine cradle. Install screw through routing clamp and secure hose to left side of engine cradle.
7. Route pressure hose along front of engine cradle. Install screw through routing clamp (1) and secure hose to front of engine cradle (2).
8. Tighten pressure (3) and return (1) hose tube nuts at steering gear (2) to 47 Nm (35 ft. lbs.) torque.
9. Install belly pan.
10. Lower vehicle.
NOTE: Always use a NEW O-ring on the end of the pressure hose.
11. Lubricate NEW O-ring on power steering pump end of pressure hose with clean power steering fluid.
