Magnum SRT-8 V8-6.1L VIN 3 (2006)
NOTE: Always use a NEW O-ring on the end of the pressure hose.
2. Lubricate NEW O-ring on steering gear end of pressure hose with clean power steering fluid.
3. Install pressure hose (2) to steering gear (1). Do not tighten tube nut at this time.
4. Route pressure hose along right side of engine cradle. Position pressure hose (1) routing clamp over return hose (2) routing clamp, then install
screw (4) securing hoses to right side of engine cradle (3).
5. Route pressure hose along front of engine cradle. Install screw (5) through routing clamp securing hose to front of engine cradle (3).
6. Tighten pressure hose tube nut at steering gear to 47 Nm (35 ft. lbs.) torque.
7. Install belly pan.
8. Lower vehicle.
