Magnum SRT-8 V8-6.1L VIN 3 (2006)
Power Steering Pump: Service and Repair
Pulley
PULLEY
REMOVAL
1. Remove power steering pump from engine.
CAUTION: Do not hammer on power steering pump pulley or shaft to remove power steering pump pulley. This will damage pulley and power
steering pump.
2. Mount Puller (2), Special Tool C-4333, on power steering pump pulley (3). Mount Puller (with power steering pump (1)) in a vise as shown; Do
not mount pump in vise. Placing Puller in vise will keep shaft of pump from turning while removing pulley (3) and help keep tension on Puller and
pulley hub.
3. Tighten Puller and remove pulley from shaft of power steering pump.
NOTE: Inspect pulley. Replace if pulley is bent, cracked, or loose.
INSTALLATION
CAUTION: Do not hammer on power steering pump pulley (2) or pump shaft to install pulley. This action will damage pulley and power steering
pump.
1. Place power steering pump pulley (2) squarely on end of power steering pump shaft.
2. Place Installation Spacer (1), Special Tool 6936, on top of pump pulley (2).
