Magnum SRT-8 V8-6.1L VIN 3 (2006)
5. Remove nuts (2) from upper control arm mounting bolts (1).
6. Raise and support vehicle.
7. Remove wheel mounting nuts (3), then tire and wheel assembly (1).
8. Disconnect wheel speed sensor cable routing clip (2) at brake tube bracket (3).
9. Loosen nut (4) attaching upper ball joint stud (1) to knuckle. Back nut off until nut is even with end of stud. Keeping nut on at this location will
help keep end of stud from distorting while using Puller in next step.
