Magnum SRT-8 V8-6.1L VIN 3 (2006)
2. Install bolt and nut (2) mounting link (3) at knuckle. Do not tighten bolt at this time.
3. Install tire and wheel assembly (1). Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.) torque.
4. Lower vehicle.
5. Position vehicle on alignment rack/drive-on lift. Raise vehicle as necessary to access link fasteners.
6. Tighten compression link fasteners to:
^
Bolt at crossmember - 85 Nm (63 ft. lbs.) torque.
^
Bolt at knuckle - 81 Nm (60 ft. lbs.) torque.
7. Perform wheel alignment.
Spring Link
SPRING LINK
REMOVAL
SPRING LINK
1. Raise and support vehicle.
2. Access and remove rear spring.
3. Export Only - If servicing right spring link, disconnect headlamp leveling sensor (1) link at spring link (3).