Magnum SRT-8 V8-6.1L VIN 3 (2006)
^
(2) Nut
^
(3) Spherical Washer (4) Thrust Bearing
^
(5) Sleeve 9361-4 (RWD)
^
(5) Sleeve 9361-5 (AWD - Left Side)
^
(5) Sleeve 9361-6 (AWD - Right Side)
NOTE: When installing thrust bearing on Remover, be sure to place hardened side against nut. Place bearing outer cage against stationary
component.
NOTE: It is important to use appropriate Sleeve on Remover to provide proper Tool-to-Knuckle contact. RWD sleeve can be used on either side
while AWD knuckles require specific left or right side Sleeves.
7. Thread Remover Bolt 9361-3 (1) into tapped knuckle sleeve.
8. Rotate Nut down, matching Sleeve angled end with angled face of knuckle.
9. Continue to rotate Nut until knuckle sleeve is removed from knuckle. Discard knuckle sleeve; replace it with new upon installation.
10. Remove bolt and nut (1) fastening spring link (4) to crossmember.
11. Remove spring link (4).
SPRING LINK - SRT8
1. Access and remove rear brake rotor on side of repair.
2. Access and remove rear spring on side of repair.
