Magnum SRT-8 V8-6.1L VIN 3 (2006)
7. Remove shock absorber (1) lower mounting bolt (2) and nut (4).
CAUTION: When removing crossmember mounting bolts (2 and 3) it is important NOT to loosen or remove crossmember mounting bolts on
opposite side of vehicle. Doing so will require rear wheel alignment following reinstallation to ensure proper thrust angle.
8. Remove both front and rear crossmember mounting bolts (2 and 3) on repair-side of vehicle. If equipped with AWD, be sure to not to misplace
spacers between crossmember mounts and body.
CAUTION: To avoid damaging other components of vehicle, do not lower crossmember (1) any further than necessary to remove shock absorber.
9. Slowly lower jack allowing repair-side of crossmember to drop. Do not lower jack at a fast rate. Lower jack just enough to allow toe link mounting
bolt at crossmember.
