Magnum SRT-8 V8-6.1L VIN 3 (2006)
17. Tighten toe link (1) fasteners to:
^
Nut at crossmember - 108 Nm (80 ft. lbs.) torque (This nut may be tightened after rear wheel alignment toe is set. Do not tighten from bolt
head end.).
^
Bolt at knuckle - 81 Nm (60 ft. lbs.) torque.
18. Perform wheel alignment.
RIGHT LINK
1. Slide crossmember end of toe link (1) into box bracket on crossmember. Slide cam bolt (2) through bracket and link from rear of vehicle.
2. Install bolt (3) and nut securing link to knuckle. Do not tighten bolt at this time.
3. While holding toe adjustment cam bolt from rotating (cam facing upward), Install cam washer (2) and nut (3) securing toe link at crossmember (1).
