Magnum SRT-8 V8-6.1L VIN 3 (2006)
29. Assemble tools (See following list) over bushing as shown.
-
(1) Bolt
-
(2) Nut
-
(3) Washer
-
(4) Receiver 9520-4
-
(5) Remover 9520-3
-
(6) Thrust Bearing
30. While holding Nut (2) from rotating, using hand tools, tighten Bolt (1) until Remover (5) comes in contact with bushing and Receiver (4) sets
squarely against crossmember.
31. Continue to tighten Bolt (1), pressing bushing out of crossmember.
32. Remove tools with bushing.
INSTALLATION
NOTE:
-
It is important that tapered end (3) of bushing be installed first into forward end of cross-member to ease installation.
-
When installing Thrust Bearing (7), be sure to place hardened side toward Bolt head.
1. Insert tapered end of NEW bushing (3) into forward end of crossmember bushing bore.
2. Assemble tools (See following list) through cross-member and bushing as shown.
-
(1) Bolt
-
(2) Disc 9520-1
-
(3) Bushing
-
(4) Nut
-
(5) Washer
