Magnum SRT-8 V8-6.1L VIN 3 (2006)
24. Once mounts are lined up with location marks, on both sides of vehicle, measure distance (1) between the tension link (2) and weld flange (3) on
body directly in front of it, just outboard of the front mount bushing (4). This distance must be at least 12 mm to allow proper clearance for
suspension movement. If distance is less than 12 mm on either side of vehicle, shift that side of rear crossmember directly rearward until distance
is 12 mm or greater. To do so, loosen 3 mounting bolts slightly, leaving one on opposite side of shift snugged to pivot off of. Shift crossmember
rearward and snug loosened bolts. Remeasure opposite side to be sure it still maintains minimum 12 mm distance.
25. Tighten all four crossmember mounting bolts (2 and 3) to 180 Nm (133 ft. lbs.) torque.
26. Remove jack (3) from under rear axle differential.
