Magnum SRT-8 V8-6.1L VIN 3 (2006)
CAUTION: In following step, use care not to damage ball joint seal boot while sliding Puller, Special Tool 9360, into place past seal boot.
9. Using Puller (2), Special Tool 9360, separate upper ball joint stud (1) from knuckle.
10. Remove nut (4) from end of upper ball joint stud (1)
11. Tip top of knuckle outward using care not to overextend bake flex hose.
12. Remove shock assembly from vehicle.
DISASSEMBLY
The shock assembly must be removed from vehicle for it to be disassembled and assembled.
For shock assembly disassembly and assembly, use of shock Spring Compressor, Pentastar Service Equipment (PSE) tool W-7200, or equivalent, is
recommended to compress coil spring. Follow manufacturers instructions closely.
WARNING: Do not remove shock shaft nut before coil spring is compressed. Coil spring is held under pressure and must be compressed,
removing spring tension from upper and lower mounts, before shock removal.
